Réviser 0 0.00

0-Produits
Taxe 0.00
Global 0.00
Livraison gratuite Leadshine ND2282 3 pièces par lot 2 Phase analogique Lecteur Pas À Pas Directe 220/230 AC Entrée Max 8.2A

Livraison gratuite Leadshine ND2282 3 pièces par lot 2 Phase analogique Lecteur Pas À Pas Directe 220/230 AC Entrée Max 8.2A

€ 380.00
€ 427.26
 

Pas cher Livraison gratuite Leadshine ND2282 3 pièces par lot 2 Phase analogique Lecteur Pas À Pas Directe 220/230 AC Entrée Max 8.2A, Acheter Moteur Pilote de qualité directement des fournisseurs de Chine:Livraison gratuite Leadshine ND2282 3 pièces par lot 2 Phase analogique Lecteur Pas À Pas Directe 220/230 AC Entrée Max 8.2A

Dans l'existence
Montant

Notice :            We only supply genuine Leadshine servo motor drive with reasonable price, if your budget is limit, please contact our service man online and he she will recommend you the low price other supplier.   ND2282 - 2 Phase Analog Stepper Drive   (3 pieces per lot)     The ND2282 is a high performance and low noise microstepping driver based on pure-sinusoidal current control technology. It’s suitable for driving 2-phase and 4-phase hybrid stepping motors. By using advanced bipolar constant-current chopping technique, the ND2282 can output more torque than other drivers at high speed. The microstep capability allows stepping motors to run at higher smoothness, less vibration and lower noise. Its pure-sinusoidal current control technology allows coil current to be well controlled with relatively small current ripple, therefore smaller motor noise and less motor heating can be achieved. In addition, the ND2282 has a built-in EMI filter which can make the driver operate with higher reliability.     Features : High quality, cost-effective Low motor noise and heating Supply voltage up to 220 VAC (310 VDC) Output current up to 8.2 A(5.86 ARMS) TTL compatible and Opto-isolated inputs Automatic idle-current reduction Input frequency up to 200 KHz 15 microstep resolutions selectable Suitable for 2-phase and 4-phase stepping motors DIP switch microstep & current settings Support PUL/DIR & CW/CCW modes     Electrical Specifications     Connector         Microstep Resolution Selection And Current Setting       Typical Connection     Mechanical Specification     Companion products 86 HS35 (Stepper Motor) 86 HS45 (Stepper Motor) 86 HS85 (Stepper Motor) 110 HS12 (Stepper Motor) 110 HS20 (Stepper Motor) 110 HS28 (Stepper Motor)     Real Photo :      

Données du produit

Type de moteur:
Moteur pas à pas
Numéro du modèle:
ND2282
Control Mode:
Step & Dir, or CW/CCW
Max Input Frequency:
200 KHz
Supply voltage:
220 VAC
Output Current:
8.2 A
Logic Current Range:
7-16mA (10mA typical)
Communication Type:
RS232
Step Width:
1,500 ns
Isolation Resistance:
500M Ohm
Protection:
Over-current, over-voltage, and stall
Suitable For:
2-phase and 4-phase stepping motors

Meilleure catégorie qualifiée